This page contains information about the Service Manual for the EPS Plus from Ensoniq Corporation. Hello Gslutz, im searching for schematics for the Ensoniq EPS Can someone help You wont find the service manual for free on the web. 21 EPS—16 PLUS Service Manual Table of Contents — 1 Table of Contents . For more information about the Poly-Key Keyboard assembly, see ENSONIQ.
|Published (Last):||22 October 2017|
|PDF File Size:||16.50 Mb|
|ePub File Size:||18.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
ENSONIQ EPS 16 PLUS SERVICE MANUAL Pdf Download.
This manual is a large Meg. Setting The Input Level Remove the two 2 self tapping screws from each side of the unit. J4-DISK, pin ribbon cable c. Save Current Sequence If you must, wrap the entire unit in plastic first. Section 6 – Wavesample Parameters There are two test operations which the program can perform: Insert And Delete Create New Instrument Make Loop Longer Remove the two screws that fasten the cartridge cover to the rear panel of the EPS.
What Is A Song If you must replace a Main Board with a 1 Main Board, three cables must be replaced. This should be done ONLY as a diagnostic function. Make sure the Disk Drive ribbon cable is not caught under the Servic standoffs.
ENSONIQ EPS MUSICIAN’S MANUAL Pdf Download.
These peanuts may cause severe damage to the Disk Drive or Keyboard assembly. Remove the Volume and the Data Entry knobs.
Remove the janual 4 machine screws and star washers from each side panels of the unit the ones that could attach the mounting ears. Disconnect the two cables from the OEX-8 board. When replacing a main board, you should replace it with the same version that is in the unit.
Keyboard and Rack Similarities. Note that these cables are keyed.
ENSONIQ EPS 16 Plus Service Manual
There are two test operations es the program can perform: Patch Selects And Presets Remove the eight 8 self-tapping screws and one segvice machine screw with star washer that attach the Main Board to the case and remove the board.
Carefully reconnect the four cables, paying particular attention to the alignment of pins and connectors. Press Enter-Yes and sample by speaking into the microphone You should hear what you are sampling at the Audio Output.
Reconnect the three wires to the Filter, again noting the proper polarity. Note that the OEX-8 outputs are not designed to drive headphones directly and should be plugged into a suitable line-level pre-amp such as a mixing board.
Press the board down and into place. Press Enter-Yes to start the Burn-in Test cycle.
Some drives may have had a half inch square metal plate fall out of them as a result of a glue problem. Reinstall the Power Supply screws. Disconnect the two cables from the Disk Drive, paying particular attention to the polarity see p. Wiggle the memory expander board side to side and up a bit to remove it.
Press Command, and double-click on the Instrument button.